12V 10M RGB Set - Waterproof - IR Controller 24 Key Remote LED Strip Lighting Kit SMD 5050 30 Leds a Meter
This latest set of specifications introduces two professional-grade Mains and 12V Powered RGB Kits. The primary difference here is the "Density vs. Length" trade-off. One kit focuses on high-intensity architectural lighting, while the other provides extended 10-meter coverage for larger areas like van interiors or perimeter lighting.
Technical Comparison: 5M High-Density vs. 10M Extended
Feature
5M High-Density Kit
10M Extended Kit
LED Density
60 LEDs per metre (300 Total)
30 LEDs per metre (300 Total)
Length
5 Metres (Single Reel)
10 Metres (2 x 5M Reels)
Power Draw
43.2 Watts (High Intensity)
20 Watts (Efficient)
Voltage
12V DC (with UK Transformer)
12V DC (with DC Jack Feed)
Cut Points
Every 10cm
Every 10cm
Understanding the 5M High-Intensity Kit (43.2W)
This kit is designed for "Indirect Lighting"—where the light reflects off a surface (like a ceiling or wall) to create a glow.
The Transformer: Because this pulls over 40W, the included UK plug transformer is essential. It converts your 230V mains power down to a safe 12V.
Understanding the 10M Extended Kit (2 x 5M Reels)
This kit is unique because it uses two reels. To ensure even brightness across the full 10 meters, you should use a Parallel Connection (wiring both reels back to the controller) rather than a Series Connection (plugging one reel into the end of the other).
Voltage Drop: If you connect 10 meters in one single line, the LEDs at the far end will appear dimmer and may shift colours (e.g., white turns pinkish) because the voltage drops as it travels through the thin copper strip.
Vehicle Ready: This kit comes with a DC Jack feed, making it perfect for hardwiring into a campervan, motorhome, or boat's 12V system.
Installation Secrets for 10M Projects
IR Receiver Placement: The "Infrared" remote requires “line-of-sight.” Ensure the small black sensor on the control box is not hidden behind a cabinet or under a bed frame, or the remote won't work.
Surface Prep: 3M adhesive is strong, but it hates dust and grease. Wipe the surface with Isoprobyl Alcohol before sticking the strip down to prevent it from peeling off in six months.
Heat Management: While 5050 LEDs are "cool to the touch," the 60 LED/m strip can get warm. If mounting on wood or plastic, it’s fine; if mounting on a surface that traps heat, ensure there is a small air gap.
Which kit is right for you?
Choose the 5M 60 LED/m Kit if you want bright, vibrant colours for a kitchen kickboard, a TV backlight, or a specific room feature.
Choose the 10M 30 LED/m Kit if you are lighting the entire perimeter of a van, a large walk-in closet, or a long hallway where even coverage is more important than raw brightness.
Add your review
Your email address will not be published. Required fields are marked *